Oracle —
Oracle Status — PulseX 5-Pool Liquidity-Weighted TWAP
TWAP (Conservative)
—
Spot (5-Pool Median)
—
TWAP/Spot Divergence
—
State
—
Stability Pool — Liquidation Capacity
Total Deposits
—
Total Collateral Held
—
Caller Tip (gas comp)
—
Epoch / Scale
—
When a scanned vault's debt is fully or partially covered by the Stability Pool, the card below shows a Liquidate via Stability Pool button — no pSunDAI required from you, the pool covers it and pays you a small tip. Otherwise, use the manual Liquidate action, which requires pre-holding the pSunDAI you're repaying.
Scans all vaults for liquidation opportunities. Bonus grows 2% → 5% over 3 hours after the auction clock starts. Call Mark to start the clock, then return later to liquidate at higher bonus. V9 change: the Stability Pool absorbs eligible vaults first — permissionless, no capital required from you. There's still no per-vault cooldown for the manual keeper path either — multiple liquidators can clear a large position back-to-back, each call still bounded to at least 20% of the vault's remaining debt.
—
—
Advanced: Flash-Mint Liquidation › for liquidator bots & contracts

liquidateWithFlashMint(address user, uint256 repayAmount, bytes data) — a liquidation path that doesn't require pre-holding pSunDAI. The vault sends the liquidator its WPLS collateral reward first, then calls back into msg.sender.onFlashLiquidation(...) so the caller can swap that collateral for pSunDAI (via a DEX router, using its own approvals) and repay by the end of the same transaction. A 0.2% fee on the repaid amount routes into the Stability Pool as yield (or surplus buffer if the pool is empty).

This requires the caller to be a contract implementing the IFlashLiquidationReceiver interface — a plain wallet clicking a button can't use it, since the vault's callback needs somewhere to land. There's no button for this on this page for exactly that reason: it would just revert for every real visitor. For most vaults, Liquidate via Stability Pool above is simpler and needs no capital at all — this flash-mint path exists for the case where the pool can't cover a large position and you don't want to pre-fund pSunDAI yourself.

If you're running a liquidation bot, deploy a small receiver contract that implements onFlashLiquidation(address user, uint256 collateralReceived, uint256 amountOwed, bytes data), call liquidateWithFlashMint from that contract, and settle the swap inside the callback. The regular liquidate() flow above works unchanged if you'd rather pre-fund pSunDAI directly.

Verified Contracts · PulseChain
pSunDAI Token (ERC-20)
0x1b13cFddab761372cBBF815502E38b4e3613dDF9
Vault V9
0x23669aeeaE9Fe50e9453ABB556Ff75Eae3EEB931
Oracle V9 (5-Pool PulseX, Liquidity-Weighted TWAP)
0xaaa9e184BA6Ef908c464A2c9e91B990bEAb7faB7
No admin keys No proxy No pause No upgrade path Chain ID 369 Verified on Sourcify